×

FDF125VNXVD

12.5 ( 5.0 ~ 14.0 ) Floor Standing Single Split PAC

FDF125VNXVD

Floor Standing : 12.5 ( 5.0 ~ 14.0 )

Indoor Unit - FDF125VD / Outdoor Unit - FDC125VNX
Nominal cooling capacity of 12.5kW

R410A
  • FDF125VD
  • FDF125VD

    Indoor Unit : FDF125VD

    FDC125VNX

    Outdoor Unit : FDC125VNX

  • FDC125VNX
Indoor unit FDF125VD
Outdoor unit FDC125VNX
Power source 1 Phase 220-240V, 50Hz / 220V, 60Hz
Nominal cooling capacity (Min~Max) kW 12.5 ( 5.0 ~ 14.0 )
Nominal heating capacity (Min~Max) kW 14.0 ( 4.0 ~ 17.0 )
Power consumption Cooling/Heating kW 3.89 / 3.88
EER/COP Cooling/Heating 3.21 / 3.61
Inrush current A 5
Max. running current A 26
Sound power
level*1
Indoor Cooling/Heating dB(A) 73 / 73
Outdoor Cooling/Heating 70 / 70
Sound pressure
level*1
Indoor Cooling (Hi/Me/Lo/Ulo) 54 / 50 / 48 / 44
Heating (Hi/Me/Lo/Ulo) 54 / 50 / 48 / 44
Outdoor Cooling/Heating 48 / 50
Air flow Indoor Cooling (Hi/Me/Lo/Ulo) m3/min 29 / 26 / 23 / 19
Heating (Hi/Me/Lo/Ulo) 29 / 26 / 23 / 19
Outdoor Cooling/Heating 100 / 100
Exterior Dimensions Indoor Height x Width x Depth mm 1,850 x 600 x 320
Outdoor 1,300 x 970 x 370
Net weight Indoor / Outdoor kg 52 / 105
Refrigerant Type/GWP R410A/2088
Refrigerant piping size Liquid/Gas ø mm 9.52(3/8") / 15.88(5/8")
Refrigerant line (one way) length m Max.100
Vertical height differences Outdoor is higher/lower m Max.30 / Max.15
Outdoor operating
temperature range
Cooling*2 °C -15~43
Heating -20~20
Air filter quantity Plastic net x 1(washable)
Remote control (option) wired:RC-E5 (installed) wireless:RCN-KIT4-E2 (option)
SEER 4.97
SCOP (Average climate) 3.60
The data is measured under the following conditions (ISO-T1).
Cooling: Indoor temp. of 27°CDB, 19°CWB, and outdoor temp. of 35°CDB. Heating: Indoor temp. of 20°CDB, and outdoor temp. of 7°CDB, 6°CWB.
  1. : Indicates the value in an anechoic chamber. During operation these values are somewhat higher due to ambient conditions.
  2. : If a cooling operation is conducted when the outdoor air temperature is –5 ̊C or lower, the outdoor unit should be installed at a place where it is not influenced by natural wind. If wind blows, the low pressure will drop and compressor frequency will increase, this will cause the capacity to drop and may cause the unit to break down.